Antimony smelting process generating solid wastes and dust：Characterization and leaching behaviors

A large amount of solid waste has been produced by the antimony smelting process in the＂World Capital of Antimony＂, Xikuangshan area in China. This study comprehensively investigated the physical and chemical characteristics of the various solid wastes, as well as the leaching behavior of the solid wastes, which included water-quenched slag,arsenic-alkali residue, desulfurized slag and blast furnace dust. These four types of waste were enriched in a variety of heavy metals and metalloids and more specifically with As and Sb levels up to 8.6 × 104 and 3.16 × 105mg/kg, respectively, in arsenic-alkali residue. For desulfurized slag and water-quenched slag, the leaching concentration of Sb significantly exceeded the acceptable limits during the leaching tests using the toxicity characteristic leaching procedure and the synthetic precipitation leaching procedure. In addition, As leaching in arsenic-alkali residue was extraordinarily hazardous, being three orders of magnitude higher than the regulatory level of As. According to the results of the extraction tests, all the tested wastes were classified as hazardous waste.     

Evaluation of soil washing process with carboxymethyl-β-cyclodextrin and carboxymethyl chitosan for recovery of PAHs/heavy metals/fluorine from metallurgic plant site

Polycyclic aromatic hydrocarbons(PAHs)/heavy metals/fluorine(F) mixed-contaminated sites caused by abandoned metallurgic plants are receiving wide attention. To address the associated environmental problems,this study was initiated to investigate the feasibility of using carboxymethyl-β-cyclodextrin(CMCD) and carboxymethyl chitosan(CMC) solution to enhance ex situ soil washing for extracting mixed contaminants. Further,Tenax extraction method was combined with a first-three-compartment model to evaluate the environmental risk of residual PAHs in washed soil. In addition,the redistribution of heavy metals/F after decontamination was also estimated using a sequential extraction procedure. Three successive washing cycles using50 g/L CMCD and 5 g/L CMC solution were effective to remove 94.3% of total PAHs,93.2% of Pb,85.8% of Cd,93.4% of Cr,83.2% of Ni and 97.3% of F simultaneously. After the 3rd washing,the residual PAHs mainly existed as very slowly desorbing fractions,which were in the form of well-aged,well-sequestered compounds; while the remaining Pb,Cd,Cr,Ni and F mainly existed as Fe–Mn oxide and residual fractions,which were always present in stable mineral forms or bound to non-labile soil fractions. Therefore,this combined cleanup strategy proved to be effective and environmentally friendly.     

2-萘酚生产废水综合治理与资源化利用工程实例

针对2-萘酚生产废水p H值低、色泽深,亚硫酸盐和萘磺酸盐高、COD浓度高的特点,采用酸化脱硫-两级络合萃取-氧化絮凝工艺处理,介绍了专利工艺的流程设计,给出了主要工艺设计参数及投资运行成本。工程运行结果表明,该工艺设计合理、技术成熟、处理效果稳定,2-萘酚生产废水经处理后达到GB 8978—1996《污水综合排放标准》一级排放标准要求;回收的萘磺酸钠固体可返回2-萘酚生产系统套用;反萃取黑液经蒸发浓缩,合成的减水剂产品各项指标达到或超过GB 8076—2008《混凝土外加剂》高效减水剂指标要求。     

热强化气相抽提对不同质地土壤中苯去除的影响

研究应用电阻加热强化气相抽提技术对砂土、壤土和黏土中苯去除效果的影响及作用机制.与常规抽提结果相比,在热强化处理作用下气相抽提对砂土和壤土中苯的去除效率提高了13.1%和12.3%,处理时间分别降低75%和14%.热强化处理使得黏土含水率下降,土壤渗透率升高,黏土颗粒表面羧基和乙基的吸收峰消失,有机质含量减少,苯的去除效率与对照相比提高了34%.对于砂土和壤土,热强化主要是通过促进苯在土体中扩散来提高去除效率,从而实现在较短时间内污染物质的大量去除;而对于黏土则是通过降低土壤颗粒表面有机基团的含量,从而降低污染物和土壤颗粒的吸附能力,并通过降低含水率和升高渗透率从而提高土壤中气体的扩散性能,以达到增强气相抽提效果的目的.     

固相萃取-高效液相色谱法测定水中丙烯酰胺研究

采用固相萃取-高效液相色谱法对水中的丙烯酰胺定性、定量分析。结果显示:丙烯酰胺含量在20μg/L~400μg/L之间呈良好线性关系,回归方程Y=0.476 8X+0.845 4,相关系数R为0.997 72,检出限0.1μg/L,样品回收率在71.85%~92.28%之间,相对标准偏差为3.4%~10.9%。该方法减少了有机溶剂用量,缩短了有机溶剂暴露时间,降低污染,且能满足地表水环境质量标准(GB 3838-2002)限值要求,是水中丙烯酰胺含量准确稳定的检测方法。用该方法测定了呼和浩特市引黄入呼左岸、右岸、中浅和中深4个断面水样,均未检出丙烯酰胺。     

柠檬酸对砷污染土壤的萃取优化条件实验研究

论文以新邱矿矸石山排土场土壤为研究对象,以去离子水做空白试验,选取尿素、十二烷基磺酸钠、碳酸氢钠、醋酸、柠檬酸等12种化学试剂做了萃取剂初选试验;并以柠檬酸为萃取剂进行了三因素三水平L9(33)正交实验。实验结果表明:柠檬酸和氢氧化钠可作为砷污染土壤的萃取剂,具有良好的萃取效果。柠檬酸作为砷污染土壤萃取剂的最优化条件是液土比为10mL/g,萃取时间为12h,萃取剂浓度为0.1mol/L。实验结果可为砷污染土壤的治理提供参考。     

反渗透膜面细菌胞外多聚物提取方法研究

城市污水脱盐系统的反渗透(RO)膜面生物污堵问题严重影响了该技术的稳定运行,解析生物污堵机理的关键因素是微生物胞外多聚物(EPS)特征分析,然而目前细菌EPS提取方法多样,无统一标准,制约了EPS分析的可靠性和可对比性.基于此,本文以再生水厂RO膜面污堵物中分离的细菌为对象,采用水浴、超声、离子树脂、碱液4种方法提取EPS,以DOC和DNA含量表征提取的EPS总量和提取过程细胞破裂程度.结果表明,45℃水浴法不造成细胞破裂,提取总量多,是一种有效的提取方法.进一步对比不同提取时间条件下EPS溶液中多糖和蛋白含量变化,以及分子量、荧光特征等,综合认为提取1 h时,提取的EPS中多糖与蛋白相对含量稳定,不同分子量化合物均溶于水中,能客观地反映EPS特征.研究表明,45℃水浴1 h可以作为细菌EPS提取的适用方法应用.     

聚环氧琥珀酸萃取锰泥残渣中铬的研究

聚环氧琥珀酸(PESA)是一种具有无磷及非氮结构、环境友好型水溶性聚合物,且具有螯合多价金属阳离子的性能和可生物降解性的特征,选取其作为锰泥残渣中铬的螯合萃取剂,研究了不同pH、螯合萃取剂剂量、搅拌时间下PESA对铬的萃取率。结果表明:(1)最佳萃取条件为pH=4、PESA剂量30mg/g、搅拌时间60min;在最佳萃取条件下,铬的萃取率可达95%。(2)从结构上看,PESA是由醚基和羧基基团组成的高分子聚合物,羧基基团是与金属离子作用的主要官能团,它对Ca2+、Mg2+、Zn2+、Cr(Ⅲ)、Cr(Ⅵ)和Pb2+等有较强的螯合能力;从溶液的配位角度看,PESA与金属有较强的结合能力。因此,PESA对锰泥残渣中的铬有萃取作用。     

超声波提取西兰花中叶黄素的工艺研究

以西兰花真空冻干粉为原料，探明了超声波强化四氢呋喃提取叶黄素的工艺条件。在确定适合提取料液比后，采用正交试验研究了超声波功率、提取温度、超声作用时间对提取量的影响。结果显示，较理想的提取条件为：超声波功率400W、提取温度40℃、超声波作用时间10min。在此条件下，叶黄素提取量最高。通过方差分析可知，温度影响达到0．05的显著水平。     

土壤中钙、镁的形态分析及提取序列的研究

本文采用改进的BCR三步连续提取法对河北某食道癌高发地土壤中钙、镁进行了形态分析及提取序列的研究。实验表明：该地区土壤中镁主要以残渣态形式存在（占总量的83.66％-88.36％），钙则受提取序列的影响很大，在第一提取序列中，以酸溶态为主（74.11％-83.38％）；第二提取序列中，以有机物结合态为主（78.12％-97.17％）；第三、四提取序列中，以氧化物结合态为主（87.49％-103％）。提取剂的加入顺序明显影响到钙的各个形态的真实含量。